FAG thin wall bearing grease injection rate when using a smooth key request

On sealing thin wall bearing consumption has to fill out at the appropriate grease, opened the host Settings seal, smooth to avoid grease leakage. Keep an eye on fat content is too little, it is easy to cause the lack of fat or dry friction, impact longevity. Grease can cause excessive temperature rise. Smooth fat a lot of leakage, not only pollute the environment, and waste. Thus, into the smooth thin wall bearing grease quantity under the premise of better FAG bearing, in order to ensure smooth enough. : smooth friction of mechanical friction resistance, consisting of a local in the film appearance. Cooling temperature: after oil circulation take away heat, avoid sintering. Clean clean: after the flow of oil, cleaning appearance friction parts and metal consumption of other materials. Sealing leak proof: reduce the gas leakage and external contaminants. Rust, can adsorption in appearance, in order to avoid water, air, acid, harmful gases and contact area. Buffer: a sharp rise, launched machine cylinder pressure, all of a sudden increase of piston, piston pin, connecting rod and crankshaft oil load can accept the impact load on the buffering effect. Fat is smooth smooth fat besmear directly to the thin wall bearing between the movement appearance. But in FAG bearing raceway and slid open work smooth appearance input fat, must comply with the following five line: ( 1) Smooth fat must permeate thin wall bearing work appearance and bearing, the internal space of such talents make smooth fat energetic smooth effect. （ 2) In FAG bearing work smooth appearance shall maintain a certain amount of fat, and for some time, but to avoid too many smooth fat loss. （ 3) Input and the flow of discharge should be smooth and fat seal request differences, it is advantageous to the invasion of sewage discharge. （ 4) On the premise of guarantee good smooth, smooth to minimize the amount of fat. （ 5) Open outlet hole in smooth fat to end, in order to make the new added smooth smooth fat can squeeze out of the old fat, ensure good and smooth. Special clew, to FAG bearing grease for smooth, be sure to pay attention to the work of the smooth thin wall bearing grease temperature range, if not in the appropriate temperature range, the effect will be counterproductive.