Bearing grease don't too much! It can kill you. . .

Bearing butter a few believe it is an issue many card friends want to know, whether more or less will not reach the ideal smooth effect and economic benefits. But today we're talking about is the link between the bearing grease with ABS sensor, butter too much and not only affected the best effect of smooth, produce waste, but also causes ABS sensor failure. Fragile parts ABS probe is a compare with the increase of time, ABS probe looks will smudgy is ABS sensor probe they can all by the metal mask, but, when using, it is a fragile thing. Because of its location close to the bearing, time grows, it is easy to be dust and all kinds of ball bearings in butter so dirty, rust, fill it with the wheel gear ring dirt, affect magnetic induction detection result. The butter was ABS sensor smudgy sensor once like you couldn't see the station maintenance experience for many years, many ABS sensor fault cases are due to the bearing butter too much make up, too much butter on the gear wheel is easy to be pushed to the probe. Light effect of ABS probe flexibility, or directly from the probe can't induction gear ring, ABS system. This situation slightly better axle sensor bracket, and later hand welding device, the situation is very common, butter and metal pads falling debris and dust, all piled up to the probe appearance. Using oil cleanser use butter average daub after cleaning, avoid rust in the bushing holder and the situation of the prevention and disposal method is very simple, that is bearing don't too much butter, right amount. Liquidation only needs to probe from the scaffold, thoroughly clean clean, then in the average between the bushing and apply a layer of butter, avoid rust in the condition of the stent is present in the future. Clean finish cleaning is finished, insert the ABS probe from full ahead to stent, must be pushed to the end, with the correct way to wheel device ( See the brother hu said brake ( 4) Error Ann wheels from ABS failure) , will be able to let it return to normal work. Was covered with butter 'die' invisible ring gear in addition to the ABS sensor probe, wheel gear ring we also needs the regular stop clearing, probe and gear ring needs to clean. In liquidation, of course, we must first check the sensor probe cable can be in good condition, if the cable broken, then how to clean and no effect, can only to a change in the probe.