Japan IKO bearing failure analysis and maintenance should be paid attention to

Not all I bearing damage can be repaired, but for each damage of bearing before you consider to repair or replace new bearing, must be the reason and degree of damage assessment in order to avoid or reduce the damage once again. Bearing damage caused by many reasons, such as improper installation, filth from invading as well or water intrusion is a lot of bearing a common cause of early damage. IKO bearing and the corresponding analysis of the causes of the common damage can prolong IKO bearing life of preventive measures. Rust and corrosion: contact with water may cause corrosion damage of bearing elements and rust. Current: IKO bearing rotates the electricity may result in a groove or notch. Eccentric, eccentric, tilt, or excessive load may result in geometrical stress concentration or surface spalling preventive measures: precision machining IKO bearing seat and shoulder of IKO bearing equipment preventive maintenance, operation and peripheral parts was removed when changing suspension bearing checking, discriminant IKO bearing parts demand, in turn, can use again and record the condition of using good from bad. Second checking IKO bearing raceway surface of the rolling surface and on the surface of the joint venture and confrontation of the wear conditions of with and without damage and abnormalities in particular is to examine the raceway surface running track. Discriminant bearing can use again, to ponder on the level of the bearing damage, mechanical function, primacy, operation premise, such as checking cycle back again choice. Checking the effect, if discover IKO bearing damage and abnormal condition, please find out notice according to the bearing damage phenomena, develop countermeasures. In addition, the checking result, there are some defects, if the bearing cannot reoccupy, demand a change in the new IKO bearings.