loading

NEWS

Home  > INFO CENTER  > NEWS  > 

Bearing self - lubricating linear guide installation

Bearing self - lubricating linear guide installation

2020-06-04

When several sets are installed simultaneously

· Free combination of products with specifications

For free-combination specifications of self-lubricating linear guides, install sliders with the same interchangeability mark ("S1" or "S2") together with sliders

· Products with non-interchangeable specifications

For non-interchangeable self-lubricating linear guides, do not change the combination of sliders and sliders on delivery.

· Sets of products to be used as a group

Ii. Assembly of slider and slide track

Special configuration (auxiliary mark "/ W ") for use as a set of products, which have been adjusted for mutual tolerances at the time of delivery, do not mix with other sets when installed.

When assembling the slider and the slide track, align the slider and the slot of the slide track correctly, and move the slider parallel and gently.Rough handling can damage the gasket or cause the ball to fall off.

Since the ball is fixed, the self-lubricating linear guide can be installed and removed freely, and the slider can be more easily installed on the slide track if an auxiliary tool (guide) is used.

The guide rail is attached to the single slider of the free combination specification and the complete set of models shown in Table 26. Other models can also provide guide rail. If necessary, please consult IKO.

Iii. Machining accuracy of mounting surface

If the installation accuracy of self-lubricating linear guide is poor, it may produce a huge load exceeding the calculated value, which will affect the life of the linear guide, so attention must be paid to the installation.

According to the requirements of working conditions such as kinematic accuracy and rigidity, the machining accuracy and installation accuracy of the mounting part of the slider and slide rail are guaranteed, and the installation structure that can maintain such accuracy and performance is adopted, so as to improve the reliability of the linear guide rail.

Four, the installation surface cleaning

Please remove burrs and scars on the mounting surface and base surface of the machinery or equipment installed with self-lubricating linear guide with oil and clean cloth.

5. Installation of the plug for the sliding track installation hole

When installing the specially configured slide track mounting hole with the plug (auxiliary mark "/ F") to the slide track, drive it in little by little with the flat block until it is consistent with the upper surface of the slide track.

6. Tightening torque of fixing screw

When the other material of self-lubricating linear guide is steel, when the machinery and equipment have vibration impact or load changes greatly, or when the load torque.Please fix it with the torque of 1.2 to 1.5 times of the value in the table according to your needs. When the other side is made of cast iron or aluminum alloy, please reduce the tightening torque according to the strength characteristics of the other side.


Chat Online 编辑模式下无法使用
Leave Your Message inputting...
Thanks for your message, we will reply you soon in our working time!