Textile mechanical transmission structure

2018 - textile mechanical transmission structure 11 - Author: TOM, introduce tangent transmission is mainly used in the textile industry, used to drive the ring spinning frame, rotor spinning, twisting and draw texturing machine spindle. In principle the tangent transmission power not only to pass on a spindle, but the belt between the wheel spindle and the stress transfer power to according to certain arranged on the spindle. It also is called 'dragon belt transmission. Tangential belt can be according to the machine manufacturer, model and the size of the machine have different arrangement. The following will introduce several commonly used mode of transmission, not very detailed, simply said the advantages and disadvantages of each type, again a little bit special models and belt type depends on the circumstances. Second, a belt/single drive system tangential belt driven at one end of the machine driven by a pulley and consists of one or the other end of the two roll transfer to return to the drive. Belt is normal driver in the inside; In the lateral it drives hundreds of shaft or the rotor. Tangential belt machine at one end of a driving wheel and two at the other end of the tail wheel links, and transmitted power, inside of the belt is usually drive on the other side of spindle. Can be applied with aramid core layer of the lace TF series to solve the problem. Three, a belt/double dragon belt drive system is through the machine at the ends of the motor drive, relatively described above power drive system can be split into two motor. Can be applied with aramid core layer of the lace TF series to solve the problem. More than four, single strip/drive system drive systems, the dragon belt drive below, this kind of circumstance can use low tension of belt, the driving structure can do 60 meters long the length of the machine, can do 1500 pounds. The system requirements for motor synchronization and drum diameter tolerance requirement is very high, can appear responsible for excessive wear and impact longevity. Five, double belt drive system with two separate tangent and on both sides of the spindle driven by two separate tangential belt, respectively, each belt drive of power is the individual drive side. So on the strength of the belt and tension will be smaller. Can be applied with aramid core layer of the lace TF series to solve the problem. Six, unit drive unit drive, motor drive the central shaft, the axial section how institutions, has a separate group of spindle in each organization, such as each section 24 ingot, etc.