Non-standard bearings which should be paid attention to in use

Non-standard bearings which should be paid attention to in using the source: bearing | last updated: - 2020 08 - 31 which should be paid attention to in the use of non-standard bearing 1, one year after the normal use of non-standard bearings should be replaced 2 # spindle oil and coarse fine filter. 2, the normal using pump station to make up for the oil must be 3 layer filter for silk cloth. 3, when the main shaft pulley, wheel loading and unloading must be under the conditions of pumping station operation. The spindle under the conditions of static pressure oil float. So don't damage the spindle and dynamic pressure bearing. 4, grinding wheel spindle survey 'before the pump station pressure and static pressure head can be within the standard size. 5, equipment mainly; Must be stopped first grinding head motor; After waiting for grinding wheel stopped; To turn off the pump station; Or simple grinding head injury. 6, in pumping station of any components. Must first removing the high pressure oil inlet hose connection; After replacing the parts; Rear oil loop of 15 ∽ 20 minutes into the tubing can be connected to grinding head; Thus ensure the into the grinding head spindle oil is super clean spindle oil through fine filtering. Doing so can extend the use of dynamic pressure spindle longevity. Non-standard bearing maintenance habits is very important in the equipment used for non-standard bearing the special bearing is not standardized, on many occasions is likely to be used, and to a large degree on applications where the environment is relatively poor, use for a long time, the maintenance cycle is long. So how to carry out maintenance has become a need to focus on research topics. As a kind of steel structure of non-standard bearings, once appear rusty phenomenon, can affect to the service life of non-standard bearings, so we should try to avoid non-standard bearings come in contact with water. If non-standard bearing is applied to some of the more bad environment, it is for the water erosion is inevitable, so for steel waterproof the most basic way is to apply a layer of anti-rust oil, evenly daub on bearing a layer of anti-rust oil or it is placed it to soak in the antirust oil, make its surface adsorption layer of anti-rust oil, and can be through the control of the oil temperature to determine the thickness of the oil. Another way is to use the rust cleaning detergent for non-standard bearing, and then use dry cloth will be wiped clean the surface of the non-standard bearing, the dip in a cleaner brush on it evenly wash is ok. Second can also use chemical cleaning methods, the use of a chemical preparation to remove rust, then put the bearing chemicals to immerse inside, after to rust has been cleaned up to be wiped out. Want to avoid non-standard bearing corrosion method still has a lot of, depending on the bearing use environment, the clean method also each are not identical, clean way to choose to suit the environment to remove rust easily. Also it is important to note should avoid non-standard bearings used in strong acid, strong alkali environment.