The joint bearing is a spherical sliding bearing with the inner sphere and the outer sphere as the sliding contact surface.It is made by many special processing methods, such as surface phosphating, frying, inlaying, spraying and so on.The joint bearing has the characteristics of strong bearing capacity, impact resistance, corrosion resistance, abrasion resistance, self-alignment and good lubricity.

Radial joint bearing

(1)GE.E: single outer ring, no fuel tank.It can bear radial load and axial load with small axial load.

(2)Ge.ES: single seam outer ring with lubricating oil groove, which can bear radial load and axial load with small axial load.

(3)Ge. Es-2rs, geew.es-2rs: single-seam outer ring with lubricating oil groove and sealing ring on both sides, which can bear radial load and smaller axial load.

(4) GE.Esn type: single seam outer ring, GE...Type XSN: double slit outer ring with lubricating oil groove (split outer ring), outer ring with stop groove.Able to withstand radial load and small axial load.However, when the axial load is carried by the stop ring, the bearing capacity of the axial load will be reduced.

(5)Ge.HS type: inner ring with lubricating oil groove, double half outer ring, the gap after wear can be adjusted, can bear radial load, axial load is small.

(6)Ge.DE1: the inner ring is hardened bearing steel, and the outer ring is bearing steel.In the inner ring assembly, extrusion molding, lubricating oil groove and oil hole, the inner diameter is less than 15 mm, no lubricating oil groove and oil hole.Can bear the radial load, the axial load is small.

GE (7).DEM 1: the inner ring is hardened bearing steel, and the outer ring is bearing steel.When the inner ring is assembled, the bearing is extruded.After the bearing is loaded into the bearing housing, the end groove is pressed into the outer ring to fix the bearing shaft.Able to withstand radial load and small axial load.

(8)Ge.DS: outer ring has assembly groove and lubrication groove.Limited to large size bearings.It can bear radial load and axial load in any direction (the assembly groove side cannot bear axial load).