Non-standard bearing rotates too much noise is not so good quality

Non-standard bearing rotates too much noise is not so good quality source: bearing | last updated: - 2020 11 - 04 non-standard bearing rotates too much noise is not so good quality some non-standard bearings under the condition of the rotation, has a very big noise, and some of the customer was not very care about this kind of noise, but it is not, it is a kind of don't pass the main performance, because if non-standard bearing noise is very big, which can confirm the space inside is too large, it will make itself under the condition of the application, shorten life, and also very easily into the sand, also has a non-standard bearing noise is due to internal roller bearings, motor rotor can make noise, namely can prove that the concentricity is insufficient, the non-standard bearings under the condition of the application, of course, also can reduce its service life, there are many non-standard bearing application of not long-term, a loose situation has taken place, is its own sound a lot of choose and buy goods. Non-standard bearing in the operation of the situation, will encounter many different problems. Such as running speed is slow, grease can be used to sort this problem out, also have the rotary noise too much, it is likely to be due to the non-standard bearing specifications. Customer if found some problem in the whole process of application, can in time to establish contact with the official online customer service. Who read this article also browse: non-standard bearing quality distinguish on several aspects of the idea 1, according to the surface of many of felt that the whole process of sales bearings bearing quality customer said if the bearing surface bright is cost-effective, it is wrong. Bearing surface brightness to dark, this is bearing with stainless steel plate is unqualified, the cutting process and cutting oil is commonly used, the former two dominant. 2, the fillet is bright bearing fillet not decisions bearing quality, but it reflects the bearing mode of production and processing. Rounded corners for a film, it shows that the bearing strength improved after heat treatment such as heat treatment process. But some people think the rounded is colored, not good-looking. Production and processing is not all a misunderstanding. 3, the whole ball bearing ratio is superior, the two bodies while the new technology and new technology with the ball bearing, but just to save raw materials, improve the spinning performance of two bodies. Overall, the bearing has relationship with three elements, could the one is the quality of the bearing itself. Second, the application of the natural environment. Three is to install method.