Taking advantage of bearings

After the bearing on the generator bottom cover is damaged, it is difficult to remove it without the appropriate tools. At this time, you can first place the bottom cover of the generator upside down on the workbench, put it on a soft wooden board or piece of cloth, add an appropriate amount of butter to the bearing of the bottom cover, and then cut some rags and stuff them into the bottom cover of the bearing. between. The smaller the piece of cloth you add at the beginning, the better. When the gap between the bearing and the bottom cover is relatively large, you can continue to increase the size of the piece of cloth. First place the cut piece of cloth on the added butter, then find a round steel or screw with a diameter that is not much different from the inner diameter of the bearing and a flat end. Use a hammer and round steel to hit the piece of cloth, and continue to add butter. and cloth, the gap between the bearing and the cover will continue to increase until the bearing is removed.