KH series bearings
The length (height) of the drawn outer ring linear bearings of the KH series with an inner diameter of 14 and 12 mm is 28
PRODUCT
Non-standard bearing inner failure treatment method
by：Waxing
2020-11-15
Non-standard bearing inner failure treatment source: bearing | last updated: - 2020
07 -
24 non-standard bearing inner failure treatment 1, non-standard bearing damage.
Check ball of ball bearing or bearing bush of ball bearing is damaged.
If there is any damage should be repaired or replaced.
2, lubricating oil with impurity, too dirty, oil ring stuck or brand is wrong.
Should check the reason stuck in oil, repair, when oil viscosity is too large, should change the lubricating oil.
3, non-standard bearing indoor short of oil.
Should add grease with two-thirds of the oil level of oil chamber or add lubricant to the standard line.
4, non-standard bearing grease in the jam is too much, the eccentric bearing lubricating oil temperature too low or too high.
Should remove excessive grease in the rolling bearing, or the oil indoor full of grease to 2/3.
5, bearing and shaft, bearing and end cover with too loose or too tight, too tight will make the whole deformation eccentric bearing, too loose prone to 'run'.
Bearings and shaft too loose when the journal can be coated metallic paint, the tight to processing;
Bearing a loose end cover set close together with end cover, the tight to processing.
6, two of the motor end cover or didn't assembled bearing cover, it is usually not parallel, overall eccentric bearing is not in the correct position.
The two end cover or stop bearing cover mouth flat, tighten the bolt.
7, belt too tight, too loose or bad coupling assembly.
Adjust the belt elasticity;
JiaoZheng coupling.
8 and maintenance in the wrong bearing type.
To replace the right type of bearing as soon as possible.
Custom message
Related Products
