Basic requirements for bearing materials
What are the basic requirements for bearing materials
PRODUCT
Nc machine tool mechanical alignment of the note
by：Waxing
2020-10-05
In the numerical control machine tool electricity after normal, should be paid attention to during the mechanical and electrical alignment: 1, the first worldwide, for each axis is, reverse point move operation, action is correct, then in AUTO mode test run simple programs.
2, spindle and feed shaft commissioning, should first after low speed high speed, and positive and reverse experiment was carried out.
3, first press the distance protection switch, test and verify the reliability of its protective effect, and then to slow distance test, verifies the correctness of overtravel collision block installation.
4, after waiting for manual action correctly, and then complete the axis and operation.
The shaft before return to participate should reverse away from the reference point some distance, don't return to participate in the vicinity of reference point, so as to avoid can't find the reference point.
5, in testing the selected knife, adjustable air knife, first observed in knife action is right or not, after waiting for correct exchange true knife again.
6, to a workpiece processing program, including a variety of functions as much as possible of instructions and auxiliary functions, the displacement size within the limit of the range of machine tool.
At the same time increase, delete and modify the operation of the procedures involved.
Finally, run the program to observe the machine work is normal.
Custom message
Related Products
