How to install and remove the SKF bearing, and to use

With Allen wrench to loosen the lock screw on the eccentric bearing sets, and then with a small iron rod inserted into the roof sink hole on the eccentric sleeve, against the direction of the axis of rotation to play loose eccentric sleeve. Unscrew the fixed bolt of the bearing. From the bearing, together with the bearing on the shaft will be unloaded. Should be on the other end of the shaft bearing bolt loosening, lest bearings on both ends don't strength and damage to each other. To shaft SKF bearing before installation, you must first remove the bearing a coat of fixed pin, the shaft neck at the same time clean exterior burnish is smooth, and in the shaft neck oil anti-rust and lubrication ( Allows for a slightly bearings on the shaft rotation) 。 Coating on surface of the bearing and the bearing lubricating oil, put the bearing into the bearing seat. Pushed to the required location for installation. Fixed bearing bolts do not tighten, let bearing coat in bearing internal energy. Also installed on the same shaft, on the other side of the bearing and shaft turning laps, make automatic alignment position bearing itself. Then good bearing bolts. Eccentric sleeve. Make the eccentric sleeve installation is firm, socket head cap screw on the eccentric locking sleeve made judgment standard according to the mechanical properties and important degree and inspection cycle. If you have the following injury, bearing shall not be used again, must be replaced. 1) Bearing parts of rupture and defects. 2) The raceway surface material on the surface of the rolling strip. For SKF bearing into full play and keep its long-term performance, must earnestly to do regular maintenance ( Regular inspection) 。 Through proper periodic inspection, do early detection of fault, prevent accident arrangement is very important to increase productivity and efficiency. 1, cleaning: bearing will be removed to check, with photography method such as first and then record the appearance. In addition, to confirm the amount of residual lubricant and lubricant sampling, and then clean the bearing. A, bearing cleaning divided into rough washing and fine washing, can be put in use at the bottom of the container and on the metal frame. B, rough washing, oil using a brush to remove grease or adhesive. If at this time in oil bearing, pay attention to the rolling surface due to foreign bodies such as damage. C, fine cleaning, slowly rotating bearings in the oil, must be carefully. Commonly used cleaning agent for neutral aqueous diesel or kerosene, according to the need to sometimes use warm lye, etc. No matter use which kinds of detergent, often should filter clean. After cleaning, immediately on the SKF bearing coating anticorrosive oil or antirust grease.