Forklift drive axle bearing maintenance and

Forklift drive axle, bearing 2020 - maintenance and 02 - 12 drive axle of maintenance: because of the underground trackless equipment type and type is more, the use of drive axle structure is not identical also, therefore, the technical requirements of its maintenance has is different. The following only provide general technical requirements and the maintenance cycle, maintenance of drive axle to have special structure and special maintenance technical requirements of drive axle, can refer to the maintenance manual. Every 10 h ( Per class) Should make maintenance for the drive axle. The content of the maintenance including shelves check the oil seal, cover, screw and the assembly gasket leaks oil. Oil seal wear, vent plug, connecting bolt looseness, drive axle shell oil level is too high, which may cause leakage. Underground trackless equipment working 100 h (per Or a week) Must check the main clutch shell and the oil level inside the wheel edge reducer, should be added. Underground trackless equipment 1000 h per work, should replace the drive axle of main actuator shelves inside the shell and the wheel gear reducer in the lubricating oil. Oil drain shall be carried out while oil is hot, and diesel to join the new gear oil after cleaning. Oil change at the same time, should be unscrewed the bridge shell vent plug and clean. Generator bearing damage on the bottom cover, if it does not have the right tools it is hard to remove. At this moment, can pour generator bottom cover on the work table first, mat is soft wood or cloth, add the butter in the bottom bearing, cut some more cloth quickly into the bearing between the bottom cover. Began to join the cloth as small as possible, when bearing the clearance between the bottom cover and relatively large shelf, can continuously increase the cloth. To cut cloth on add butter, then find a bearing inside diameter and the diameter of the root were small and flat at one end of round steel or screw, with a round steel percussion piece, and constantly add butter and cloth, and cover the gap between the bearing will continuously increase, and remove bearing.