Bearing too much butter, could produce such consequences. 。 。 。 。 。 - bearing knowledge

Bearing butter how many believe is an issue many friends want to know, whether more or less will not reach the ideal lubrication effect and economic benefit. However, what we call today is bearing the butter and the correlation of the ABS sensor butter too much affects not only the best lubricating effect, produce waste, but also can lead to ABS sensor failure. ABS probe a relatively fragile parts although ABS sensor probe surface almost entirely by the metal cover, but the actual use, it is a fragile thing. Because of its location close to the bearing, time grows, it is easy to be dust and all kinds of ball bearings in butter dirty, rust, even fill it with the wheel gear ring dirt, affect magnetic induction detection result. Be butter covering many ABS ABS probe sensor fault cases was caused by a bearing too much butter, too much of the butter when installing wheel is easy to be pushed to the probe. Light effect of ABS sensor sensitivity, or as a direct result of probe can't induction gear ring, let the ABS system failure. Both axle sensor bracket, and later hand welding installation, this kind of situation is very common, butter and metal pads falling debris and dust, all piled up to the surface of the probe. Use oil cleanser use butter evenly daub after cleaning, prevent rust in the bushing holder. And the prevention and treatment method is very simple, that is when bearing butter, do not too much, right amount. When clearing only need to remove probe from the scaffold, thoroughly clean, then evenly between its and bushing a layer of butter, prevent rust in the case of stent in the future. Cleaning is completed, the ABS probe fully inserted into the holder from behind, and must be pushed to the end, with the right wheel installation method, can let it return to normal work. In addition to the ABS sensor probe, the wheel hub on the gear ring and we also need to clean up regularly, probe and gear ring needs to be kept clean. When cleaning, of course, we first need to check whether the sensor probe cable is in good condition, if the cable faults, so how to clean and no effect, only to change the probe. Actually out ABS sensor probe and the ring gear method is very simple, and no bother our imagination, as long as the ABS system works well, we only need to observe when confirmed round their cleanliness. Such ability can let the ABS system can always accurate monitor the running status of the wheel.