Remove the sieve imported SKF bearing method

Vibrating screen machinery used a lot of people, vibrating screen machine the easiest bad place will be imported SKF bearing inside. If installed with imported SKF bearing is better, if install the bearing that is much worse. Some see master of vibrating screen machine on inside of SKF bearing imports also is not very understanding, it will cause some damage, now of the vibrating screen SKF imported bearings are generally installed imported SKF bearing, so the question is a lot less, but due to the imported SKF bearing life also to have certain limitations, it also needs to be maintained, if bad also need to remove, easy to remove the sieve imported SKF bearing? Imports may cause improper removal of vibrating screen bearings, SKF bearing internal damage. Pollutants can enter the SKF bearing imports or errors may be produced during installation. Therefore, remove the vibrating screen bearings have to be careful, axis must have the appropriate support, or remove the power may be hurt and SKF bearing imports. The screw hole cover usual blind plug, vibrating screen separation of tapered roller bearing type imported SKF bearing, shoulders set several incisions in the shell, using block, remove by press, or tap the disassembly. 2, sieve cylinder hole remove the inner ring of the remove of imported SKF bearing, can use simple mechanical pull out the latest pressure. At this time, must pay attention to the inner ring under the pulling force. Large vibrating screen imported SKF bearing inner ring remove oil pressure method is used. By setting on the axis of hydraulic oil hole, in order to make easy to pull out. Width of the large imported SKF bearing, oil pressure method and drawing fixture and disassembly operations. NU, NJ cylindrical roller bearing vibrating screen is the inner ring of disassembly can take advantage of the induction heating method. In a short time heating the local, make the inner ring expansion after drawing method. 3, import bearings SKF tapered bore remove the removal of relatively small band set set of imported SKF bearing, with fastening on the shaft gear support inner ring, the nuts back a few times, use block with a hammer beating the disassembly.