Prolong the service life of bearing, mastering knowledge - bearing these points

Bearing as an important joint parts, machinery and equipment in order to prolong the service life of bearing, the use of the daily maintenance is again hard to avoid, to live longer, for bearing use more appropriate to chop the bearing network through bearing all aspects of understanding, to share knowledge of daily for maintenance and maintenance of bearings, as long as mastering these points, is clearly did not issue to bearing's life continue. First of all, to make the bearings and keep its long-term performance into full play, must earnestly to do regular maintenance ( Regular inspection) 。 Second, regular check on bearing, such as defective must do early detection, prevent accident arrangement is very important to increase productivity and efficiency. Third, bearing in the factory are coated with the right amount of anti-rust oil and anti-rust paper, as long as the packaging is not damaged, the quality of the bearing will be guaranteed. Fourth, after long-term storage, such as bearing in humidity below 65%, under the condition of temperature is 20 ℃ or so, in the shelf 30 cm above the ground is advisable. In addition, the place should avoid direct sunlight or of safekeeping and touch the walls of the cold. Fifth after cleaning bearing, bearing maintenance process, the need to be the steps as follows: a, first of all, the bearing will be removed when check, use methods such as photography first and then record the appearance. In addition, to confirm the amount of residual lubricant and lubricant sampling, and then clean the bearing. B, bearings cleaning rough washing and fine washing, can be put in use at the bottom of the container and on the metal frame. C, coarse, washing oil using a brush to remove grease or adhesive. If at this time in oil bearing, pay attention to the rolling surface due to foreign bodies such as damage. D, fine cleaning, slowly rotating bearings in the oil, must be carefully. Commonly used cleaning agent for neutral aqueous diesel or kerosene, according to the need to sometimes use warm lye, etc. No matter use which kinds of detergent, often should filter clean. E, after cleaning, coating anticorrosive oil or antirust grease on the bearing immediately. Sixth, in the bearing removal and installation, be sure to use professional tool and the corresponding safety procedure for bearing installation and unloading.