Jiaxing bearing small make up for your wheel bearing installation and maintenance points

There is rotational, have HRB bearing ( ) Jiaxing bearing group sales co. , LTD. ( The company) Is bearing group co. , LTD. Established in jiaxing spot sales window, specializing in HRB brand bearings, facing the whole country, the existing stock 50 million yuan, covers the whole bearing, have very strong spot supply, is the group's retail sales center. 1 prior to the installation wheel bearings, wheel bearings, first check the mounting surface of the host, for supporting members should have sufficient strength, junction surface should be mechanical processing, surface smooth without sundry and burr. Mechanical processing for unable to meet the requirements of planeness, can use special plastic filler injection intensity, to ensure the accuracy of the installation plane and for vibration reduction. Wheel bearing ring with quenching soft belt region, in the ring on the face of all marked 'S', when installation should be in the position of the soft belt on the load area or not often load area ( Plug hole is always located on the soft belt) 。 Installing a wheel bearing, should be advanced ways to locate, cross tighten mounting bolts, and monitor the rotation of the bearing. And tighten the screw down the bolt should be enough, it shall be the bolt pretightening material yield limit of 70%. Install bolts should be with conditioning flat washer and spring washer is strictly prohibited. 2, wheel bearing maintenance: installed and functioning of the wheel bearing after the continuous running 100 hours, should be a comprehensive check installation bolt pre-tightening torque is in line with the requirements, after each repeat this check a continuous run of 500 hours. Wheel bearing installed should fill the right amount of grease, and should be filled and slewing bearing with grease evenly distributed. Wheel bearing at work after a period of time, will inevitably lose part of grease, so the wheel bearings in normal operation intervals of 50 ~ 100 hours after a grease should be added. 3, wheel bearings, transport and storage: bearing in the process of transportation, should be placed on the vehicle, due to prevent sliding and the measures to prevent vibration, plus auxiliary support when necessary. If you are looking for the above jiaxing bearing group co. , LTD. The author introduces the bearing inspection and replacement of interest or have any questions, please click on the website on the right side of the online customer service or call:, you close the way of jiaxing bearing purchasing advisors. - - - - - - Editor: jiaxing bearing sourcing consultant LTD. All rights reserved, The company) Reprint please indicate the source