From the spherical roller bearing quality problems using orbit

Rolling bearing is precision components, and its use should be measured accordingly. No matter how high performance using TIMKEN bearings, if use undeserved, will not get the desired performance. Use of bearing the note below. One, keep the bearing and the surrounding environment clean even invisible to the naked eye of tiny dust into the spherical roller bearings, also can increase the bearing wear, vibration and noise. TIMKEN bearings and its surrounding accessories should be kept clean, especially the dust and dirt, tools and working environment must be clean. Second, use the installation should be careful when not allowed powerful punch, are not allowed to use hammer, tap on a bearing directly, don't allow through the transfer roller pressure. Three, using appropriate and accurate installation tools use a special tool, as far as possible to avoid use cloth class and short fiber, things like that. Four, to prevent rusting of the bearings directly with the hand take bearing, to fully wash hands sweat, and again after coated with high quality mineral oils, especially in the rainy season and summer to pay attention to rust. However, in some special operating conditions, self-aligning roller bearings can get more than the life of the traditional computing, especially in the case of light load. These special operating conditions is, when the rolling surface ( Track and rolling piece) Can be separated by a lubricating oil film effectively and the surface of the limit of pollutants may cause damage. In fact, under ideal conditions, the so-called permanent bearing life is possible. TIMKEN bearing a move, take outer ring raceway surface of the inner ring, because take rolling body is rolling contact, so running track for the dark side, running track is attached raceway surface is not very, if he could learn that load change, so is remove the bearing, bearing the seal of what type? 。 Please keep close attention to track and view the raceway surface movement. If carefully examined the running track, will know that only bear radial load, bear the axial load of big, inherit the torque load, or is not on the bearing housing extreme rigid is not equal. To a raid of TIMKEN bearing can add the dismantling of any load and error, such as being able to nus and become fled to check bearing damage for clues. If no choice errors and can perhaps use words accurately, until the bearing life, use for a long time, however, is that kind of environment, mutilate form for stripping. On the other hand, bearing tooling management system design and implementation. Also without any late damage, and can't use the advanced mutilate, as the advanced the cause of the damage, no use and lubrication considerations do not apply, and also with no intrusion, remove the error of the TIMKEN bearing and shaft deflection, the research of shaft and bearing box does not apply, and so on.