TIMKEN taper roller bearing with skills pay attention to four points

Check the status of the operation of the machine and thorough examination of preparatory plan has been more and more serious. By over-packaging TIMKEN bearing as the focus, because it is the most important machine of all rotating parts. Condition monitoring is an important part of the preventive maintenance. Early detection of bearing damage in order to avoid because of the tapered roller bearing damage caused by the unscheduled maintenance equipment during outage. However, not all and is equipped with the advanced instruments. In this case, the machine operator or maintenance engineers' fault signal of TIMKEN bearing must be on high alert, such as noise, temperature and vibration. 'listening', 'touch' and 'observation' is the first four important factors, to keep the TIMKEN bearing and the surrounding environment clean need not say I will know what is going on, even invisible to the naked eye of dust into the bearings, also can make of taper roller bearing wear, to put it bluntly, knead no sand in the eyes, is a way! The second point, careful to use installation where you won't even that common sense all can't, if not, then don't do tapered roller bearings, go home and play, the most important strength is not allowed in stamping, are not allowed to use hammer percussion bearing directly, not afraid of smashed, you give up deformation, how to do, take a loss yourself, ha ha, there is not allowed to pass through body pressure. The third point, using appropriate, accurate installation tools to use a special tool, to avoid use cloth class and short fiber, things like that. Fourth, to prevent the corrosion of TIMKEN bearings, don't use bubble bearing is made of stainless steel, but also afraid of water, if not letter, you put in the water bubble, ha ha, take the circular cone roller bearings with the hand, should fully wash hands sweat, and again after coated with high quality mineral oils, especially in the rainy season and summer to pay attention to rust, don't tell me the rust of be afraid of what, well, you try it yourself, and see what the result is rust! Right choice to cooperate, we must know the actual load condition of tapered roller bearings, working temperature and other requirements, but in fact it is very difficult. As a result, most of the time, is according to the use of lapping choice to cooperate.