The requirements of the sliding bearing scraping the inquiry

Basic requirement is to make the journal sliding bearing and the close contact, and it is certain to should have fit clearance. Contact Angle refers to the journal and sliding bearing contact area of the central Angle. Contact Angle is not too big nor too small. Contact Angle is too small will make sliding bearing pressure increases, serious when they make the sliding bearing produces large deformation, accelerate wear, shorten service life. Contact Angle is too big, can affect the formation of oil film, can't get good fluid lubrication. Experimental research shows that the limit of the sliding bearing contact Angle is 120 °. When the sliding bearing wear and tear to the contact Angle, fluid lubrication will be destroyed. So don't affect the sliding bearing compressive conditions under the premise of the smaller the contact Angle is better. From the theoretical analysis of the friction torque, when the contact Angle is 60 °, minimum friction torque, so, the speed is higher than 500 r/min of sliding bearing, contact Angle 60 °, speed is less than 500 r/min of sliding bearing, contact Angle can be used in a 90 °, 60 ° is used. Journal contact point and the actual situation of the sliding bearing surface contact, available per unit area of the actual contact points. The more contact, more and more even, said sliding bearing scraping the research better, on the other hand, sliding bearing scraping the inquiry is not good. In general the more the more close contact point, research difficulty is large. Production should be based on the performance of the sliding bearing, and working conditions to determine the contact information listed in the table below for reference: sliding bearing speed ( r / min) The contact point ( Every 25 x 25 mm area contact points) 100 the following 3 ~ 5 100 ~ 500 10 ~ 15 15 ~ 20 1000 500 ~ 1000 ~ 2000 20 ~ 25, 2000 above 25 above Ⅰ and Ⅱ precision machinery can use the above data, Ⅲ level precision of the machine can press the table data in half. So-called bearing shell, is the essence of the car after the roof tiles and shaft assembly by hand research ( Shaft to apply toner) With triangular scraper scrape off the tiles on the attached pink, increases with the increasing research, until the tiles on the attached color area is more than 85% of the whole on the surface of the tile, complete tile. Tiles of the knife is the miniature tiles stored lubricating oil reservoir.