What are the methods and key points of bearing heating installation?
What are the methods and key points of bearing heating installation?
PRODUCT
The cause and the treatment method of motor IKO bearing overheating - bearing knowledge
by：Waxing
2020-06-14
1, IKO bearing damage.
Should be replaced.
2, rolling IKO bearing grease too little, too much or has the impurity such as iron filings.
IKO bearing capacity of the grease should not exceed 70% of the total volume, have impurities should be replaced.
3, shaft and IKO bearing fit too tight or too loose.
Should be tight to grinding, must be set to a shaft with too loose.
4, IKO bearing and end cover too tight or too loose.
Too tight when processing IKO bearing chamber, too loose inside the end cover set steel bushing.
5 and motor end cover or IKO bearing cover assembly.
Will end cover or IKO bearing cover check into mouth, flat, tighten the screws.
6, belt too tight or bad coupling assembly.
Adjust the belt tension, coupling correction.
7, sliding IKO bearing lubricating oil is too little, have impurities or oil ring stuck.
Should come on, change new oil, repair or replace the oil ring.
Custom message
Related Products
