How to correct lubrication maintenance way of SKF one-way bearing

SKF bearing common installation tools have a hammer, tongbang, socket, special plate, screw the mosquito jig, press, etc. , measuring vernier caliper, micrometer, dial gauge, etc. , but according to the different bearing types to choose different tools. After choose the right tools, can the bearing installed, when installation should pay attention to have no bruising, rust layer, abrasive dust, sand, dust and dirt, can cause installation if any difficulty, must maintain a one-way bearing surface and cooperate with the assembly parts surface clean. In addition to one-way bearing assembly surface and cooperate with the surface of the parts are clean, but also pay attention to the journal, the surface of the bearing shell hole, shoulder end face, and connecting parts such as bushings, washer, end cover rust layer of these places? If there is one can use smooth file away, fine emery cloth, install again. Rolling bearing is precision components, and its use should be measured accordingly. No matter how high performance bearing use, if use undeserved, will not get the desired performance. Grease on the bearing has a very important role in protection, in order to better play of SKF bearing grease lubrication, we need to follow the standards of six: first: mechanical stability; Grease in the mechanical processing will become soft, resulting in leakage. During normal operation, oil will by the bearing to the bearings. If the mechanical stability of the oil is insufficient, operation process, the structure of the soap grease causes mechanical disruption of oil was damage, and loss of lubrication. The second: can't mix oil; Never mix the fat off from the incompatible, if two incompatible oil mixture, usually will soften its consistency, might end up bearing damage caused by oil easy to loss. Third: the oil seal to rigorous; Oil seal is necessary to protect and lubricant from the barrier of contamination from SKF bearing, bearing in the process of operation, regardless of debris or moisture can penetrate bearings, in case of causing damage to it. Fourth: classification of grease and choice; Mainly according to the temperature and the working conditions to distinguish: grease can be classified according to their allowable working temperature, lubrication grease consistency and ability is affected by temperature, operating under a certain temperature must choose a one-way bearing under the same temperature has the correct consistency and good lubrication effect of oils and fats. Fifth: rust resistance; Use within the SKF bearing grease must have antirust effect, rust inhibitor is best can not dissolve in water. Grease should have good adhesion, and can form a layer of oil film on the surface of steel. Sixth: oil viscosity; If the wrong choice grease all preventive measures of the one-way bearing is useless, choose a grease, its oil viscosity in working temperature is it is important to be able to provide adequate lubrication effect, viscosity is mainly affected by temperature, it with the temperature rising and falling, is that it increased when the temperature decreases.