How to better maintain the TIMKEN bearing import fever - bearing knowledge

Maintain good bearings is the essential condition of TIMKEN bearing import operation, the commonly used maintenance is for bearing lubrication, in reading how to select the bearing lubrication method, under the premise that knowing bearing lubrication method, it is necessary to know about bearing system maintenance is also, let's look at how to make the bearing lubrication maintenance. 1. To maintain the clean bearing lubrication on the TIMKEN bearing import inspections should be clean before bearing surface, and then carefully check the bearing oil seal and the surrounding parts, if has presented the adverse symptoms, be sure to replace, and bad seal will cause damage to the bearing cloud caused by abnormal equipment downtime. 2. Pay attention to cover exposed check TIMKEN bearing import bearings don't let the noise of the bearing's exposure to pollutants or moisture environment. If the job is interrupted, should with oil film, paper or similar material by machine. If don't have to remove and may perform inspection of cleaning without masking of bearing, to clean with brush with petroleum solvent coating, then dry with a lint-free cloth or with compressed air to blow dry, Be careful not to let the bearing component starting rotation) 。 With a little mirror, and the probe used in the similar to the dentist to check the bearing of the orbit plane, retainer and beads. Do not clean the encrypted block or dust bearing; You just wipe the outer surface. If the bearing is need to replace damaged situation. During regular maintenance downtime time replacement bearings than the array bearing damage of selected into a sudden stop loss is much more economical. 3. It is important to check the bearing lubricant lubricant is not only in view of the bearings, also for all of the bearings. Note, however, TIMKEN bearing import shoulds not be too much grease. And then replace the bearing lubricant. Use after xie used engine oil, engine oil lubrication bearing if possible, should be impregnated with fresh oil and let the machine in low speed rotation for a few minutes. As far as possible make the oil collecting residual pollutants, and then purging in addition to the oil. And the use of grease lubrication bearing in replacing grease, Joe used in addition to the device should be avoided with any part of the cotton material come into contact with the bearing. Because these residues fiber may wedged in between the scroll and damage, especially the application of bearing more need to pay attention to this problem.