Design software selection pressure bearing, bearing and how to install

RS— — With the contact seal ( Referred to as the seals) Bearings are often used to secondary pollution and inevitable, such as water or water splash, or require no maintenance of long-term service life of bearing in the configuration. Clearance adjustable bearing means can move the relative axial bearing raceway position to obtain the required clearance, belong to this class have cone bearing and angular contact ball bearing and thrust bearing. The internal structure of outer spherical ball bearing and deep groove ball bearings are the same, but this kind of bearing inner ring width in the outer ring and outer ring with truncated spherical outside surface, and can automatically adjust to match with the concave spherical surface of the bearing. Pressure into laws ( Also known as the cold installation) : a, the solution: sound intensity bigger, bearing the coordination relations for inspection, found that the problem timely repair, - is the heating temperature is suitable - Degrees, high degree of no more than, this several different bearing steel, respectively with constraints on the corresponding standard requirement. mm - mm； Wear width: mm, flat compressor can only use the upper air inlet, the upper exhaust structure; And the cone type compressor can use side or the upper air inlet, lower exhaust structure. Light ISO size series is heavier than series or series are more easily affected by such damage, bearing and the bearing fitting surface with lubricating oil, the double row tapered roller bearing load bearing. Should be paid attention to in the process of moving cone operation, the temperature of the lubricating oil, pay attention to protect oil dredge, when lubricating oil metamorphism, lubricating oil should be filtered or replaced timely cleaning, keep good lubrication of the moving cone. Operation in the process of using all normal operation, observe the various parts of the bearing surface situation and parts to determine the effect of lubrication conditions and surface temperature, failure of bearing repair and maintenance records, cold hot acid pickling process or method test of bearing parts, decarburization layer and surface had original soft point, especially in surface grinding. Therefore, vertical mill parts repair, especially its shaft straight is the enterprise to pay attention to the problem of industrial problems, such as sauvy carbon nano polymer technology, is now relatively perfect and mature item repair process. Scene image: roller press in different phases of operation, the wear of the roll face is different, use manufacturers want to combine the situation of wear on the surface of the roller, using the above no longer process was carried out on the roller surface protection line repair in time, it is very necessary. Carbon nano polymer technology, combined the field blow grind recovery process or the tooling recovery process can restore the bearing wear, not only real high, fast recovery time, and restore capital low. At this moment, it is recommended that the cage inside don't apply too much grease, ( Filled with sealing ring of bearing, grease or don't need to wash) Bearing use kerosene or gasoline as a cleaning fluid.