Bearing pictures: automotive steering machine bearing water what reason

Due to the high speed bearing makes every effort to reduce the relative sliding and internal friction, SKFC/DB angular contact ball bearing is good not to use relative displacement of the inner and outer ring along the axial approach to adjust clearance of ball bearings. When cleaning, of course, we first need to check whether the sensor probe cable is in good condition, if the cable faults, so how to clean and no effect, only to change the probe. Heat insulation and cooling, interlocking don't careless, can, for example, for the purity of the work environment, according to the seriousness of the pollution, can L life by a coefficient, the coefficient of from. To open, can install and remove from the central part of the shaft directly, can repair, thick wall: have sufficient strength and rigidity, can reduce the bearing hole machining accuracy requirements. Bearing and shaft diameter d, base hole system, but the tolerance zone located below the zero line, the upper deviation as compared with the base hole system like, in conjunction with the same name are more likely to get more close cooperation. Shaft repair, spline, slotting, thread repair available gas welding or surfacing welding method to repair worn tooth profile, then on the basis of the wear and tear of the spline, milling spline. Image for the company to film, rustling figure will investigate main use: single: machine tool spindle, high frequency motor, gas turbine, centrifugal separator, small car front wheel, differential pinion shaft. Whatever the test in the laboratory or in actual use, can be clearly seen, under the same working conditions, the appearance of the same bearing the actual life. Ready before installing the necessary parts, tools and equipment installation, repair process is simple: to not wear surface as a benchmark, sauvy tooling repair technology is adopted to improve the online repair. Five big and constitute principle of bearing ring & amp; #; Bearing ring structure, its main purpose is to reduce the hardness, improving cutting workability, and to prepare for after quenching. High-speed bearing compared with low-speed bearing, the precision of the bearing steel ball or roller is different, and the precision is higher than the precision of the low-speed bearing raceway, high-speed bearing of high rank and good material, such as steel microstructure, hardness, etc. Affected by the production environment, processes, the proportion of different industry is different, the use of machine selects the high quality carbon steel plate, turning into a circular ring, after being solidified material, machining according to fit size, main shaft wall, but the inverter display for power output fault reasons: may be the phase voltage imbalance.