TIMKEN bearing installation quality to the life and performance

Scroll TIMKEN bearing is precision components, and its use should be measured accordingly. No matter how high performance bearing use, if use undeserved, will not get the desired performance. Use of bearing the note below. A, keep the TIMKEN bearing and the surrounding environment clean even tiny dust into the TIMKEN bearings, invisible to the naked eye also will increase the wear of the bearing, vibration and noise. Bearings and its surrounding accessories should be kept clean, especially the dust and dirt, tools and working environment must be clean. Second, use the installation should be careful when not allowed powerful punch, are not allowed to use hammer, direct hit TIMKEN bearings, don't allow through the transfer roller pressure. Three, using appropriate and accurate installation tools use a special tool, as far as possible to avoid use cloth class and short fiber, things like that. Four, to prevent rusting TIMKEN bearing directly take TIMKEN bearings, with the hand to wash hands fully the sweat, and again after coated with high quality mineral oils, especially in the rainy season and summer to pay attention to rust. However, in some special operating conditions, bearing can get more than the life of the traditional computing, especially in the case of light load. These special operating conditions is, when the rolling surface ( Track and rolling piece) Can be separated by a lubricating oil film effectively and the surface of the limit of pollutants may cause damage. In fact, under ideal conditions, the so-called permanent TIMKEN bearing life is possible. Correct TIMKEN bearing installation program has the following points: first, to ensure the installation environment clean. If TIMKEN bearing with iron filings, burr, dust and other foreign matter to enter, will make the TIMKEN bearing noise and vibration during operation, and even damage raceway and rolling body. So, before the installation of bearings, must ensure that the installation surface and the environment clean. Bearings after installation, if not serious for alignment, alignment may result in bearing suffered another load, friction, and vibration. Might be accelerated by fatigue and reduce the bearing service life, and it might damage the other machine parts service life. In addition, the increase of vibration and friction could significantly increase the risk of energy consumption and premature failure. Finally, through the replacement of the grease to improve the bearing running environment. By Yu Run fat varieties, quality is in constant improvement and change, the old equipment to new TIMKEN, grease should be after the test, trial rear can officially use; When change the new fat, should first remove waste grease, clean parts clean. When adding grease, waste should be fat extrusion, when fat mouth see new grease.