The characteristics of 16008 / HR11TN bearing manufacturing

16008 / HR11TN bearing manufacturing what are the characteristics of the source: bearing | last updated: - 2020 06 - 14, 16008 / HR11TN bearing manufacturing what are the characteristics of non-standard bearing friction maintenance skills of non-standard bearing role is to make the non-standard bearing retaining ring and rotating ring with the fixed part ( Usually bearing) And rotating parts ( Usually bearing) Consolidation together. Axis) 。 Collectively, completed in the condition of rotating transfer load and determine the position of the sports system relative to a fixed system of basic tasks. Non-standard bearings need to be in the radial, axial and tangential direction of three general its position on the shaft and bearing housing. Radial and tangential positioning by closely cooperate with double row of non-standard bearing ring. The axial positioning used only in a few cases; Usually use the tight fit; Usually use the axial limit components, such as end cover and retaining ring, limit the axial location within the scope of the clearance. Biaxial non-standard bearings on the shaft diameter to direct contact with the bushing directly with preventing adhesion and boundary lubrication performance. Factors influencing the friction pair of friction compatibility of materials including: ( 1) Metallurgy of alloy formed as auxiliary material. （ 2) The affinity of material and lubricant. （ 3) The lubrication state of friction coefficient of secondary materials. （ 4) The material microstructure. （ 5) The thermal conductivity of the material. （ 6) The size of the material surface energy and the characteristics of the oxide film. Oil pump through the nozzle of high pressure oil injection bearing, non-standard bearing oil injection through a bearing on the other side of the tank. When bearing at high speed, rolling element and cage also with relatively high rotation speed form the air flow around. In general it is hard to lubricating oil lubrication method to the non-standard bearings. At this point, you must use the high-pressure jet method will double row of non-standard bearing lubricating oil injection, the position of the nozzle should be between inner ring and maintains a center.