PRODUCT
- Rod End
- Agricultural Bearing
- Water pump shaft bearing
- Oil seal
- Adapter Sleeve
- Slewing Bearing
- Ball Screw Bearing
- Joint Bearing
- Oilless Bearing
- Car Spare Parts
- Forklift Bearings
- One-way Bearing
-
Ball Bearing
- Spherical Ball bearing
- Thrust Ball Bearing
- Deep Groove Ball Bearing
- Angular Contact Ball Bearing
- Roller Bearing
- Pillow Block Bearing
- Needle Bearing
- Linear bearings
- EPDM CR v-belt pk belt
Four points of the bearing when applying correct installation
by:Waxing
2020-09-19
(
1)
Work together as much as possible through the axis of the bearing, this requires the screws even symmetry and smooth, by spherical or parallel to the axis force application.
(
2)
Wire should be smooth and uniform, the size of the unfavorable impact, this request can use hydraulic or use steady pull or pressure tool, it had to use hammer, also want to through soft without exfoliation metals such as copper sleeve to buffer, tapping force as gently as possible.
It is best to use copper or copper hammer hammer.
(
3)
Avoid by applying pressure roller, which requires the inner ring (installation
Axial circle)
When applying pressure through the inner ring and outer ring installation)
Through the outer power works.
(
4)
The extent of the drag force continued to be, for example, when installing a bearing in the bearing fit into the correct position to stop work, guarantee the ring (
Washers)
The end face of landing on a hole or shaft shoulder end, neither packed too tight, nor does not reach the designated position.
Custom message
Do not allow empty
Do not allow emptyPlease enter a valid e-mail format
Do not allow empty