FAG one-way bearing inspection and fault handling in operation

FAG bearing inspection project has a one-way bearing during operation of rolling noise, vibration, temperature, lubrication condition and so on, details are as follows: 1. Bearing the rumbling of the sound device is adopted to the size of the rolling sound of FAG bearing in operation and the quality inspection, a one-way bearing even with slight stripping damage, such as would an exception and irregular, and with the sound of the measuring device can distinguish. 2. Bearing the vibration of the bearing vibration is sensitive to one-way bearing damage, such as peeling, indentation, rust, crack and wear will be reflected in the FAG bearing vibration measurement, therefore, through the use of special bearing vibration meter ( Frequency analyzer, etc. ) Can measure the size of the vibration, through frequency analysis can deduce the abnormal situation. Measured values of bearing or sensor installation position and different using conditions, thus requiring prior to each machine is analyzed by the measured value of the determined after judgment standard. 3. The temperature of the bearing FAG bearing temperature, usually have a bearing on the surface of the outdoor temperature can be predicted, if using the oil hole can directly measure temperature of bearing outer ring, is more appropriate. Usually, the temperature of the one-way bearing with operation began to slowly rise, 1 - After 2 hours to reach steady state. The normal temperature of bearing for machine heat capacity, heat dissipating capacity, rotational speed and load. If FAG bearing inspection and fault handling of lubrication operation, installation of appropriate, bearing temperature will rise sharply, appear unusually high temperature, then must stop running and take necessary precautions.