The removal of all types of TIMKEN bearing method

TIMKEN bearing of remove and install the same carefully. Note not TIMKEN bearing and the damaged parts, especially interference fit TIMKEN bearing down, and the operation is difficult. So, in the design stage to consider in advance to facilitate disassembly, designed and manufactured according to need remove the tools is also very important. When disassembling, according to the drawings the disassembly method, sequence, investigate the matching of the TIMKEN bearing conditions, to ensure foolproof disassembly operations. 1, the outer ring of the removal of removal of interference fit of the outer ring, beforehand in setting several outer shell on the circumference of a circle of extrusion screw with screws, one side equal to tighten the screw, remove. These cover usual blind plug, screw hole taper roller type TIMKEN bearing separation of TIMKEN bearings, shoulders set several incisions in the shell, using block, remove by press, or tap the disassembly. 2, remove the inner ring of the remove of cylindrical hole bearing, can use simple mechanical pull out the latest pressure. At this time, must pay attention to the inner ring under the pulling force. Large TIMKEN bearing inner ring remove oil pressure method is used. By setting on the axis of hydraulic oil hole, in order to make easy to pull out. Width of TIMKEN bearing is oil pressure method and drawing fixture and disassembly operations. NU, NJ cylindrical roller bearing inner ring remove can take advantage of the induction heating method. In a short time heating the local, make the inner ring expansion after drawing method. 3, taper hole remove the removal of relatively small band of TIMKEN bearing set set of TIMKEN bearings, with fastening on the shaft gear support inner ring, the nut back a few times, use block with a hammer beating the disassembly. Large TIMKEN bearing, using the hydraulic remove easier, in the oil hole on the shaft taper hole pressure oil, make the inner ring expansion, remove the TIMKEN bearing method. Operation, the possibility of TIMKEN bearing suddenly emerge, it is best to nut used as gear block as well.