Regular maintenance INA outer spherical bearing maintenance steps

Need to stress is that links outside the spherical bearing lubrication and cleaning is very important. So when we inspect the INA bearing, ohlendorf clean the bearing, and then remove the perimeter of the bearing parts. To pay more attention to the master, it is cowardly of oil seal parts, fruit and inspects and cockiness special care is needed when demolition demolition, not excessive force, so that form the damaged parts. Then carefully check the outer spherical bearing oil seal and its surrounding parts, if not present adverse symptoms, be sure to switch off, bad seal will result in bearing damage, make the INA bearing a cloud constructed disambiguation and forming equipment downtime. Need to pay attention to is the outer spherical bearing cover show. Absolutely don't let the bearing show in pollutants or moisture. If workers do outside compose, when the oil film or similar materials cover paper-plastic machinery. If it is needless to remove the possible inspection under the sight of cleaning without masking of bearing, with coated with the brush of female with petroleum solvent ( whitespirit) Cleaning and dry with a lint-free cloth or with compressed air to blow dry, Pay attention to don't let the noise of bearing component starting to reverse) 。 With a small mirror female, and the type of probe used in the same dentist to check INA bearings orbital plane, connector and bead of female. No cleaning encrypted block or dust bearing; You just wipe its external situation. If the bearing is damaged need to switch off scene. Are scheduled downtime aftercare period change bearing nearly than for array bearing damage selected into Russia but stop lose much more economical. 1, first put INA bearings in gasoline cleaning, wipe the residues of sludge and dust on the bearing, bearing all rusty wipe gently with the metallographic sandpaper polished, until no fingered rough feel. 2, use dry cloth to clean the outer spherical bearing wiped dry, soaked in the anti-rust oil again. In this process, will fully contact with the anti-rust oil bearing, don't stop rotating bearing, so that the rust-proof oil forming oil film covering on the surface of bearing, achieve the goal of rust. 3, the next use lithium base grease? Butter? Should be evenly coated on the surface of bearing, including inside and outside the ring, wheel, cage. And wipe while rotating bearing, makes the butter into the real bearing internal, sufficient lubrication effect. 4, the last procedure is packaging. In order to save costs, we 'waste', scrapping of cement bags in the warehouse, the packing bag of cut into appropriate size, the outer spherical bearing good tight, package, label after good bearing specifications back on the store shelves. 5, use NSK thermal monitoring of INA bearings working temperature at any time. If the bearing temperature for a long time even the transfer of more than 125 ℃ lower bearing life.