How to check the lubrication status of bearings during operation?
How to check the lubrication status of bearings during operation?
PRODUCT
How to install the roller bearing
by：Waxing
2020-11-20
How to install roller bearing source: this website the author: the administrator to release time: 2013 -
10 -
15 08:13:54 views: 0 roller bearing is indispensable accessories products, machinery and equipment installation steps are required for the installation operation strictly.
Step, first to press the bearing into the bearing before washed with kerosene, with clean hands daub evenly fill shell 3 lithium base grease to the two-thirds full to roller bearing outer ring, use add bolt locking glue binding bolt clamp mount NTN bearing gland.
Second step, if there are any models was inside and outside the set of separable bearing cylindrical roller bearing, bearing inner suit on the rotating shaft and should be in place.
The third step, if there is grease filling holes specified alignment position, for the bolt with add bolt locking glue tight bearing seat, the bearing seat is installed on the casing.
The fourth step, has a shaft roller bearing need to reload the eccentric shaft key into the key block, with a ring on the shaft.
Inside and outside the eccentric block is installed on the rotating shaft and in place.
Fifth, the rotation of the roller bearing adjustable eccentric block to make it to unload in front of the Angle position and tighten the fastening bolts.
The bolt fixed eccentric block.
Step 6, and then step is to use screw fastening on vibration motor on both ends of the cover.
Custom message
Related Products
