Bearing grease is too much, ABS sensor trouble from time to time

ABS sensor probe is a compare with fragile accessories, if say in stop bearing add butter, add more, also affects the use of ABS sensor probe, the bearing network on the basis of understanding, then discuss the link between the bearing grease with ABS sensor, butter too much and not only affected the best effect of smooth, produce waste, but also causes the ABS sensor probe failure. 1, with the increase of time, ABS sensor probe dirt is ABS sensor probe appearance looks almost all by the metal mask, but, when using, it is a fragile thing. Because of its location close to the bearing, time grows, it is easy to be dust and all kinds of ball bearings in butter so dirty, rust, fill it with the wheel gear ring dirt, affect magnetic induction detection result. The butter was ABS sensor probe 2, smudgy probe once like you couldn't see many ABS sensor fault cases are due to the bearing butter too much make up, too much butter on the gear wheel is easy to be pushed to the probe. Light effect of ABS probe flexibility, or directly from the probe can't induction gear ring, ABS system. Bearing grease is too much, which brings to the ABS sensor bad influence, how to handle? 3, butter and dust deposit to probe appearance whether axle sensor bracket, late or manual welding device, the situation is very common, butter and metal pads falling debris and dust, all piled up to the probe appearance. Using oil cleanser 4, using the butter of the average daub after cleaning, avoid rust in the bushing holder and the situation of the prevention and disposal method is very simple, that is bearing don't too much butter, right amount. Liquidation only needs to probe from the scaffold, thoroughly clean clean, then in the average between the bushing and apply a layer of butter, avoid rust in the condition of the stent is present in the future. 5, cleaning cleaning is finished, insert the ABS probe from full ahead to stent, must be pushed to the end, with the right wheel device, will be able to let it return to normal work. 6, was covered with butter 'die' invisible ring gear in addition to the ABS sensor probe, wheel gear ring we also needs the regular stop clearing, probe and gear ring needs to clean. In liquidation, of course, we must first check the sensor probe cable can be in good condition, if the cable broken, then how to clean and no effect, can only to a change in the probe.