the bearing adjustment, which is cannot be ignored after installing.
PRODUCT
Remove the back on the sleeve bearing matters needing attention
by：Waxing
2020-09-05
Remove the back sleeve bearing not only need bearing puller, but also pay attention to the withdrawal of some parts of the bearing can be easily remove the success.
If didn't notice that these sites may also damage the bearings.
China bearing network share remove withdrawal on bearing note: remove the back on the sleeve bearing, must take the axial locking devices: locking nut.
Demolition of end cover, etc.
Mail down the small and medium-sized bearings, can use the lock nut and hook spanner or impact wrench to loosen the bearing.
Remove the large bearing is the best way to use the hydraulic nut.
If collar threaded portion protrudes from the shaft end or shaft, should be inserted in the set of Jane hole support ring, support ring wall should be thick, in order to avoid when using hydraulic, tighten nut thread when the deformation damage.
Advice plus a blockage in the hydraulic nut end, through the shaft end, for example, if a withdrawal of all of a sudden and its axial separation, the obstacle can be used to avoid hydraulic nut from the shaft sleeve and back completely withdrawal.
For large bearing sleeve is generally take back with tubing groove, in order to use oil injection method, greatly shorten the time needed for installation and removal of large bearing.
【
Warm prompt.
【
The bearing network]
Some information from the Internet, and strive to secure timely, accurate, aims to deliver more information, does not represent our views to its approval or responsibility for their authenticity.
If this net reprint information involves the issues such as copyright, please contact with this net.
Tel: 0571 -
81630205.
Tags: install and remove
Custom message
Related Products
