Bearing manufacturer to introduce to you: outer spherical bearing cleaning and inspection

Bearing manufacturer to introduce to you: outer spherical bearing cleaning and inspection source: bearing | last updated: - 2020 08 - 01 outside the sphere and the cleaning and inspection of the bearing housings before installation guide, also should be checked into a comprehensive cleaning. The bearing inner cavity with a scraper dirt away, a cloth dipped in gasoline or solvent dirt rub-up, watch the crack and sand holes, in order to prevent in operation of oil leakage. Bearing cover and the bearing joint face, bearing and the bearing oil baffle in combination with surface should be crapping to cooperate, and feeler to check the clearance shall not be greater than zero. 3 mm. Place and the bottom surface of the bearing also want to clean up, should not have bruising, corrosion and burr. Tighten the screw of the bearing plate and screw are asked him to check, and try to twist screws to check whether too tight or bald buckle. To shaft bearing before installation, must first remove the bearing a coat of fixed pin, the shaft neck at the same time clean exterior burnish is smooth, and the journal oil anti-rust and lubrication ( Allows for a slightly bearings on the shaft rotation) 。 Coating on surface of the bearing and the bearing lubricating oil, put the bearing into the bearing seat. Pushed to the required location for installation. Fixed bearing bolts do not tighten, let bearing coat in bearing internal energy. Also installed on the same shaft, on the other side of the bearing and shaft turning laps, make automatic alignment position bearing itself. Then good bearing bolts. Eccentric sleeve. The eccentric sleeve installation is firm, finally lock eccentric sleeve on the socket head cap screw. ”