Bearing cleaning installation enterprise we need to pay attention to the following points to avoid damage to the bearing

High temperature bearing cleaning when installation, we need to pay attention to the following 1. High temperature affect the bearing cleaning needs a lot of research, first with a temperature of 90 ~ 100 ℃ heat oil pour hot oil in order to make our packaging condensation, at the same time with seamless all mouth and no net exfoliation tools to dig the old oil, then pour hot a few minutes, then rinse with kerosene oil, after wash themselves with traditional gasoline again. On film gloves should be worn after washing clean, high temperature will lead to bearing can work on the management level on the stage of dry clean cloth or paper. 2. Before the high temperature bearing system device design, should use the appropriate measurement tools according to the technology may request the relevant rules on the design drawings, check the shaft and hole and the working parts of the relevant state of processing and product quality ( Such as size calculation accuracy and shape accuracy and surface roughness, etc. ) 。 3. Bearing temperature, a temporary open the packaging unit, gently rotate the hand above the submerged in liquids such as gasoline, adhere to ensure framework, described in the outer race of rolling element and encapsulation thoroughly clean oil. Figure 4. Components with clean the surface of the gasoline, kerosene, toluene and xylene solution clean, dry with a clean cloth, and then coated with a thin layer of smooth oil, make the equipment operation more convenient. Washing temperature and sealed bearing, not with this law, the seal the shouldn't insist on cleaning. 6. Axis and high temperature bearing hole assembly if there is a dent on appearance, burr, rusty spot or solid particles ( Such as abrasive dust, sand, clay) Such as existence, not only this will make the enterprise high temperature affect the bearing system device is a difficult and make the design of device location information is incorrect, but also for solid particles such as falling into a high temperature bearing inner grinding technology role, when high temperature bearing can rotate to grind or bruising staff appearance of high temperature bearing, so in the device before we must need to seriously study analysis examination, such as defects found to have the above problems, should be constantly revised. Applications such as oil file to remove burrs, bump touch mark, rusty spot, with fine abrasive cloth lighting, and like a clean solid particles, dirt, etc. The previous: bearing cleaning misconduct can cause burns how to solve the next: no