To tell you how long does it take to maintain a rolling element bearing

To make the bearings and keep its long-term performance into full play, must earnestly to do regular maintenance ( Regular inspection) 。 Through proper periodic inspection, do early detection of fault, prevent accident arrangement is very important to increase productivity and efficiency. Bearing in the factory are coated with the right amount of anti-rust oil and antirust paper, as long as the packaging is not damaged, the quality of the bearing will be guaranteed. But long stored in humidity below 65%, the temperature is 20 ℃ about conditions, the shelf in 30 cm above the ground is advisable. In addition, the place should avoid direct sunlight or of safekeeping and touch the walls of the cold. How long to maintain a rolling bearing manufacturer of bearing? Bearing can use 20000 - in theory 80000 hours, but the life in the process of using depends on wear and working strength etc. Use dry cloth after cleaning the bearing wiped dry, soaked in the anti-rust oil again. In the process, to rolling bearing factory bearing completely contact with anti-rust oil, does not stop rotating bearing, so that the rust-proof oil forming oil film covering on the surface of bearing, achieve the goal of rust. Then use lithium base grease, butter, need to evenly coated on the surface of bearing, including inside and outside the circle, wheels, cage. And wipe while rotating bearing, makes the butter into the real bearing internal, sufficient lubrication effect. First put bearing in gasoline cleaning, wipe residues of sludge and dust on the bearing, bearing all rusty wipe gently with the metallographic sandpaper polished, until no fingered rough feel. After the procedure, is packing. In order to save costs, we 'waste', scrapping of cement bags in the warehouse, the packing bag of cut into appropriate size, bearing a good tight, package, label after good bearing specifications back on the store shelves. Bearing lubrication is again in the equipment downtime and implementation of the plan and added on a regular basis, at the same time, the old rid grease or via the drain the old oil out empty. Before adding fresh grease injection nozzle should be wiped clean. If there is no zerk bearing box, should open the bearing box cover or end cover, in order to remove the old grease, clean up after, supplement the same type of fresh oil.