To maintain IKO tapered roller bearing vibration testing method

Maintain good bearings is the essential condition of tapered roller bearing operation, the commonly used maintenance is smooth for IKO bearings, smooth way of how to select the bearing in reading and in smooth way of understanding the bearing the premise, is also necessary understanding of the bearing system maintenance, let's look at how to stop the smooth bearing maintenance. 1. Insist on bearing smooth clean the taper roller bearing should lead to clean bearing appearance before a stop, and then carefully check bearing oil seal and its surrounding parts, if already presents the adverse conditions, be sure to switch off and bad seal will cause damage, make IKO bearing cloud is not normal and forming equipment downtime. 2. Pay attention to cover exposed bearing inspection taper roller bearing don't let the noise of the bearing's exposure to pollutants or moisture environment. If work infix, should with oil film, paper or similar material by machine. If don't have to remove and may perform inspection of cleaning without masking of bearing, to clean with brush with petroleum solvent coating, then dry with a lint-free cloth or use a tightening air blow dry, Pay attention to don't let the noise of bearing component starting rotation) 。 With a small mirror and the probe used in the similar to the dentist to check IKO bearing the orbital plane, adhere to and beads. Do not clean the encrypted block or dust bearing; You just wipe its external appearance. If the bearing was damaged when the need to change. In regular outage remaining period change bearing than the array bearing damage suddenly stop the loss of the selected into much more economical. 3. Check the smooth bearing agent smooth agent is very important not only in view of the bearing, bearing and for all. But please note, tapered roller bearing is unfavorable smooth add too much fat. And then there is a change in the bearing smooth agent. Using the oil slick bearing after xie used engine oil, if can of words, should be impregnated with fresh oil and let the machine in low speed rotation for a few minutes. As far as possible make the oil collecting residual pollutants, and then purging in addition to the oil. Use smooth IKO bearing grease in a change in grease, the use of Joe except should prevent with any part of the cotton material come into contact with the bearing. Because of these residues fiber may wedging between rolling pieces and formation damage, the application of special bearings need more attention to this problem. The waviness on bearing ring of the self-contained parts or under the condition of the close cooperation between the shaft and bearing ring with adjacent components are likely to match the shape and deformation. If appear deformation, can produce vibration in the operation. Therefore, the bearing and the shaft to stop the machined to the required tolerance is very important. The damage due to error operation or unit, small local bearing raceway and rolling body may be damaged. In operation, rolled the damaged bearing parts will produce a certain vibration frequency. Bearing vibration frequency analysis are recognized the damaged parts. The vibration behavior of application places in many applications, IKO bearing stiffness and the stiffness of the same. Due to this feature, need to correctly select the bearing ( Including the preload and clearance) And its application in the configuration, it is possible to reduce the application of vibration.