Fag miniature bearing necessary maintenance of important operation significance

FAG miniature bearing grease is usually make a similar viscosity or apparent viscosity, said when, on the viscosity of grease must specify the temperature and shear rate. Similar viscosity index can be used to control the low temperature fluidity and pumping. Measure a fag miniature bearing grease performance at low temperature is one of the important index of low temperature torque, namely at low temperature ( - 20 ° c below) Grease block bearing rotational degree of low speed flows, the low temperature torque of the grease by the starting torque and rotation torque after 60 mm average said. The evaporative (fag miniature bearing grease C) Said in the long-term use under condition of high temperature grease, grease oil volatilization, evaporative as small as possible. The evaporative mainly depends on the nature of the lubricating oil and fat fractions. Oxidation stability is refers to the grease when used in long-term storage or long-term high temperature resistance to heat and oxygen, permanent changes in their ability to maintain its nature will not occur. Due to oxidation, are often free alkali content reduced or free organic acid content increases, drop point drop, dark appearance, appear different smell, consistency, ultimate strength, similar viscosity decreased, generated corrosive product and destroy the material of grease, soap oil separation. In long-term storage of grease, therefore, should be stored in dry and ventilated environment, prevent sun, and shall regularly check free base or free change of the project such as organic acid, corrosion resistance, to ensure its quality and performance. According to the area of use and conditions of use and environmental conditions choose size, precision, with appropriate fag miniature bearing is the prerequisite of bearing life and reliability. Use parts: fag miniature bearing is suitable for predominantly radial load under the combination of radial and axial load, usually with two sets of bearing pair is used, should be mainly in car wheel hub, before and after active transmission parts, such as bevel gear, differential, reducer. Fag miniature bearing clearance when the slightly negative is running, the largest bearing life. But actually should keep bearing the best condition is very difficult, once some using conditions change, the negative clearance increases, thus triggering a significant reduction in the self-aligning ball bearing life or fever. Therefore, often requires choosing initial clearance, running clearance off for only a slightly greater than zero.