Fag bearings in use process matters needing attention

In some special operating conditions, fag bearings can get more than the life of the traditional computing, especially in the case of light load. These special operating conditions is, when the rolling surface ( Track and rolling piece) Can be separated by a lubricating oil film effectively and the surface of the limit of pollutants may cause damage. In fact, under ideal conditions, the so-called permanent bearing life is possible. A, use when installation should careful not allowed powerful punch, are not allowed to use hammer percussion bearing directly, not allowed by transfer roller pressure. 2, using appropriate and accurate installation tools use a special tool, as far as possible to avoid use cloth class and short fiber, things like that. Third, try to keep the bearing and the surrounding environment clean even invisible to the naked eye the smile of the dust into the fag bearings, also can increase the bearing wear, vibration and noise. Four, to prevent rusting of the bearings directly with the hand take bearing, to fully wash hands sweat, and again after coated with high quality mineral oils, especially in the rainy season and summer to pay attention to rust. Rolling bearing is precision components, and its use should be measured accordingly. No matter how high performance using fag bearing, if use undeserved, will not get the desired performance. Use of bearing the note below. ( 1) And keep the bearing and the surrounding clean. Even the eyes can't see the little dust, will also bring bad influence to the bearing. So, keep the surrounding clean, dust from invading bearing. ( 2) , carefully use. In use for bearing strong impact, will produce scar and creasing, become the cause of the accident. Severe cases, can crack, fracture, so must pay attention to. ( 3) And use the appropriate operating tools. Avoid to existing tools to replace, must use the appropriate tools. ( 4) And to pay attention to the corrosion of the bearing. Operation fag bearing, hand sweat will become the cause of rust. Pay attention to the operation with clean hands, it is better to try to bring gloves.