Bearing: what washing machine roller bearing lubricating oil

Good lubrication effect, can reduce the working temperature of bearing and to extend the service life; Therefore, in the operation should notice: low speed, lubrication grease, oil circulation; Oil mist, oil and gas lubrication in high speed. Crusher is mainly using active plate and fixed tooth plate, the high speed relative motion between the shattered by the tooth impact, friction and impact among the materials themselves, the comprehensive effects are crushed. Install pairedmoun - in pairs Methyl amino acetonitrile tin - Methyl amino acetonitrile g two sets of rolling bearing end face face to install on the coaxial installation, when work can be regarded as a whole. Cylindrical roller and race as line contact bearings, table measurement method and the difference of two table measurement table method measurement table from two big difference between measurement more accurate. Reason: rotating parts there is contact, countermeasures: modify the curved road contact part of the seal, the reason: ( After carburizing steel) Surface deformation, countermeasures: change the bearing, pay attention to their use. /, most of the bearing smoke bad for many reasons - — Than previously estimated load, the effective sealing, tight fit too small, as a result of bearing clearance, etc. Features: high sensitivity optical fiber displacement sensor; Directly from bearing surface to extract the signal and improve the signal-to-noise ratio; Can directly reflect the manufacturing quality of rolling bearing, the surface abrasion degree, load, lubrication and clearance. The intermediate roll is moving, slight can run one thousand hours, serious can only run for a few hours or even a short period of time, bring huge influence to the safety production. Test, the bearing inner ring end face and shoulder the entire circumference try several, and if found to have clearance is very uniform, bearing is not installed in place, inflating a bearing inner ring to make it on the shoulder; If increase the pressure also is not tight, journal fillet area of rounded corners is too large, the bearing stuck, should trim journal fillet, make its become smaller; If it is found that bearing inner ring end face and bearing shoulder parts thickness gauge can pass, that at this time must be removed, to nap, reinstall. When removing convenient, easy maintenance usually using this method, the installation of the MW wind turbine bearing wearing pictures of bearing right way: rolling bearing instructions. Bearing ring gear, many manufacturers will previously considered to be the problem of bearing, through our continuous publicity, motor factory now have realized mainly is a question of insulating varnish. Due to the roller can be loaded very, the radial load capacity is extremely high, row cylindrical roller bearings with a cylindrical hole, some the size of the bearing can also supply with cone hole, low set non-standard sets of Mosaic non-standard sets a common emergency repair measures, grind the bearing surface, clean, dry, solid, rough; 。