How to install and remove the self-aligning ball bearing a few common reasons

Without fixed lubrication will be a problem. Artificial maintenance, is impossible to achieve, the automatic lubrication system, can develop in order to achieve the best lubricating effect. Need grease, tools and effective lubrication technology, will help to significantly reduce downtime. Although you can install 'free' for all kinds of bearing seal, but 36% of bearing early failure is still is not correct grease technology and improper use. Any improper lubrication of bearings in normal life inevitably fail to move forward. Machinery and equipment TIMKEN bearing is usually the most difficult part of the work. Bearings are precision components, bearings and oil pollution, will not be able to run. Bearing in addition, all sealed maintenance-free with oils have, at least 14% of the pollution is only in the early all self-aligning ball bearing failure caused by small use bearing significant. Bearing has excellent manufacturing and design capabilities, can provide all kinds of bad working conditions, sealing solutions. With Allen wrench to loosen the lock screw on the eccentric bearing sets, and then with a small iron rod inserted into the roof sink hole on the eccentric sleeve, against the direction of the axis of rotation to play loose eccentric sleeve. Unscrew the fixed bolt of the bearing. From the bearing, together with the bearing on the shaft will be unloaded. Should be on the other end of the shaft bearing bolt loosening, lest bearings on both ends don't strength and damage to each other. To install self-aligning ball bearing shaft before, must first remove the bearing a coat of fixed pin, the shaft neck at the same time clean exterior burnish is smooth, and the journal oil anti-rust and lubrication ( Allows for a slightly bearings on the shaft rotation) 。 Coating on surface of the bearing and the bearing lubricating oil, put the bearing into the bearing seat. Pushed to the required location for installation. Fixed bearing bolts do not tighten, let bearing coat in bearing internal energy. Also installed on the same shaft and self-aligning ball bearing, on the other side of the shaft turning laps, let the TIMKEN bearing itself automatically find is location. Then good bearing bolts. Eccentric sleeve. The eccentric sleeve installation is firm, finally lock eccentric sleeve on the socket head cap screw