High temperature stainless steel shell model

The modelling of stainless steel in high temperature by bearing 1. Institutional development and its really out of the way in the process of producing casting casting production process are analyzed, and high temperature bearing is used for clamping high temperature bearing, so as to realize a support system for shaft and shaft parts, weighs 10 kilograms parts information for HT200 castings dimension ( 215x80x146) 2 mm consumption outline: mass consumption. Due to the small casting, the veil should be adopted, acted as one wet gauze 3. Appearance design: the whole mold, active block, two cases 4 models products. Parting surface is throughout the parting surface of the bearing temperature distribution, and sand core Φ 62. 5, such as wood, and basically in a plane, so choose the bearing as the parting surface temperature distribution, the lower die cavity, this also is helpful for safe. 5. Poured riser for HT200, location is the casting concrete shrinkage of small volume, is a thick entity but the casting parts, so be wary of the problem of shrinkage cavity defects, and thus the position and direction of the SPR is very important, according to structural characteristics of our casting with controlled by directional solidification behavior criterion, the ends of the internal sprue should base on one side of the introduced at the same time, it also can effectively avoid bad Φ 62. 5 sand mold, the use of China to resist pressure side slit gate, which can continuously reduce the contact thermal gate and casting section, and can be used as prevent no thick local overheating, and can greatly shorten the production finish time of solidification, help students get to cultivate qualified casting parts, in addition, because of the pressure side gate feeding effect is good, so the demand of the castings is not feeding riser can be set, in order to avoid the hole easy to produce, can slant edge location information among top department set up is also a Φ 8 - Φ 10 mm vent riser area location. The previous: high temperature stainless steel bearing inner spherical treatment next up: none