Effects of using bearing steel rings
PRODUCT
Taking offset press the damaged bearing
by：Waxing
2020-09-20
Small axis (the operating side of the rolls in the replacement of a vase
66.
030.
059).
The broken needle bearing when met a difficult question - how to remove the damaged bearing?
Maintenance personnel use the power drill to drill to along the outside of the bearing, the hole leaving only a thin layer to cover, but is very difficult to take out his hand.
Later use small axis on the lathe, stamping tool cutting needle bearing, to remove the bearing.
If bearing damage again, a simple method is to first will be small shaft with a diameter of 5 mm along the centerline of the bit to drill a hole, and then on milling machine equipped with bearing Kong Xi deep about 1.
5 mm, inside the hole to fill, such as the thickness of the gasket after embedding bearing.
Once again bearing damage, can remove the small axis, in 5 mm diameter hole struck gaskets, bearings will take off the hole, and the effect is very good.
Custom message
Related Products
