Rotary bearing use and enjoy

Use ( 1) Rotary bearing factory is usually note the 3 # lithium base grease, customers can be based on demand to fill in the application note for smooth and fat. ( 2) Normal working conditions, the device after 100 hours of operation should be check a bolt pre-tightening force, check each running 500 hours later, must have enough pre-tightening force. Every seven years or work 14000 hours later, a change in bolt. ( 3) Under normal working conditions, the ball slewing bearing device after 100 hours after running smooth fat injection time, roller slewing bearing running smooth fat will be listed after 50 hours. Check each running 400 hours later and suitable amount of filling to insist on good smooth state, and make records. In many dust and high humidity areas when using, should according to the detailed condition to ensure smooth once a week at least. And for a long time before and after the stop shall be updated smooth fat. Every time a smooth roll need to smooth passage filled with grease. Slowly turn the rotary bearing when filling, make its energetic average filled with filling. 4) Rotary bearing tooth surface should guarantee every 8 - Ten working days to clean oil change once, never mixed with foreign body. To regularly check can rotary bearing seal is in good condition, such as the seals is shattered should be reset in a timely manner; If there is any breakage should immediately change, in order to avoid foreign body into the race. Storage and die, 1) Rotary bearing factory race has note have smooth and fat, and appearance have been coated with anti-rust oil. Rotary bearing packaging according to customer requirements, have individual packaging, also have a whole circle packing. ( 2) If not device use, should be six months to stop a surface on the surface of oil remaining in order to avoid rust, southern region for 3 months to stop a surface on the surface of oil remaining. Rotary bearing raceway. Should guarantee 1 year to stop a smooth die, die can be sensitive to rotate when rotary bearing inspection operations. All remaining after all should restore rotary bearing initial state, and film packaging. ( 3) Rotary bearing should be no corrosive medium, dull, flat interior register, do not soak or water spray. ( 4) Set rotary bearing should be smooth, prevent the vertical or inclined. Flat ( Except the whole circle packing) Between each rotary bearing uniform placed 3 - at least in circumferential direction 5 block, and the upper and the lower piece on the position of the circumference of a circle should be divided. Idle slewing bearing for many years, Much rain in the middle of the) Enabled should check, check project, please contact our qc department or service department.