Bearings for Steel Industry
Bearings for Steel Industry
PRODUCT
FAG non-standard bearing and self-aligning bearing have to differ
by：Waxing
2020-11-15
FAG non-standard bearing and self-aligning bearing have what different sources: bearing | last updated: - 2020
09 -
28 non-standard bearing and self-aligning bearing are what is the difference between two kinds of bearing is there a difference in the structure and application.
Self-aligning bearing the outside of the dovetail bearing management center for the management center of the guide rail surface, so when the inner hole and outside even if separate a certain Angle, roller bearing is still on the surface, so the center of the roller bearing and the bearing management spacing is constant, also won't produce jam or damage, namely the self-aligning bearing.
Self-aligning bearing can use on both sides of the long shaft, used to hide not enough strong point and bending strain axis.
And non-standard bearing flip is not outside of the curved surface, therefore can not fully automatic self-aligning, so he fit within the short axis of large bending stiffness.
Non-standard bearing structure simple, easy to use, suitable for high speed, the use is widespread, can bear axial force can also assume a certain number of axial force.
Self-aligning bearing capacity is small, the key bear axial load, have very good temperament, can fully automatic compensation because of axial tensile strain and casing deformation caused by the parallel misalignment, suitable anchorage hole can not be strict to the component.
Custom message
Related Products
