Bearing professional knowledge - — Mutual cooperation and application of the bearing?

Bearing professional knowledge - — Mutual cooperation and application of the bearing? Source: bearing | last updated: - 2020 10 - 25 bearing professional knowledge - — Mutual cooperation and application of the bearing? Bearing the interaction of a select and cooperate with each other the inner diameter of the rolling bearing specifications and diameter specifications are according to the grades of precision manufacturing, bearing inner hole and shaft, the lateral tight pine level only in conjunction with a hole according to the controlling motor shaft size tolerance and size tolerance of hole to complete. Interaction bearing inner hole and shaft selection base hole system, bearing the lateral choose shaft basis in conjunction with a hole. Appropriate chooses to cooperate with each other, it is important to understand the bearing standard of specific load, operating temperature and his rules, as a matter of fact, it is very difficult. Therefore, most conditions were chosen on the basis of application of fine grinding of mutual cooperation. Read this article also browse: two size, load cast a win between the ring and the shaft or housing quantity depends on the size of the load, heavy load chooses a large amount of a win, the lighter load with smaller than win volume. Who read this article also browse: bearing used common problems rolling bearing is high precision parts, so when it is applied in relatively cautious attitude, even if the application performance excellence in bearing, if the wrong operation, you can't do it forecasts the characteristics of the actual effect. Therefore, the bearing to pay more attention to the following several aspects: a, keep bearing as well as the surrounding environment clean. Even very small dust into the bearings, also can increase bearing damage, the vibration and noise. Second, earnest, carefully when installation does not allow the ultra strong stamping die, don't knock the bearing immediately, are not allowed to work according to the transmission roller pressure. Three, the installation of the application of appropriate special tools, application of commonly used tools, as far as possible to prevent the application of cloth and polyester short fibers such items. Four, avoid rust erosion of bearing, good take bearing don't have to immediately specialty, to make high quality mineral oil paint and then carry out the actual operation, especially in the rainy season and summer in the antirust processing to pay more attention to.