Daily to maintain the stability of INA bearings - bearing knowledge

Ensures the stable movement of the INA bearing finely machine, but also can ensure the daily maintenance work, especially to the core parts of bearing lubrication, and performance from the aspects of fine crusher in work projects will produce a lot of heat, and from the aspects of temperature, in the form of also have changed a lot, at the same time, in this respect, a long-term operation also has wear on the bearing form, therefore, fine crusher bearing lubrication is directly affecting the effect of the whole production line operation. Simple from below to introduce about the INA bearing lubricant fine crusher selection skills. 1, mixed oil never mix the fat off from the incompatible, if two incompatible oil mixture, usually will soften its consistency, might end up bearing damage caused by oil easy to loss. If you don't know what kind of grease bearing used is, you must first thoroughly remove bearing inside and outside the old grease, can add new grease. 2, mechanical stability grease in machining will become soft, cause leakage. During normal operation, oil will by the bearing to the bearings. If the mechanical stability of the oil is insufficient, operation process, the structure of the soap grease causes mechanical disruption of oil was damage, and loss of lubrication. 3, choice of important factor if the wrong choice grease oil, all measures to prevent bearing is useless, choose a grease, its oil viscosity in working temperature is it is important to be able to provide adequate lubrication effect, viscosity is mainly affected by temperature, it with the temperature rising and falling, is that it increased when the temperature decreases. Therefore, you must know when working temperature of the oil viscosity. 4, oil seal oil seal is necessary to protect bearings and lubricants from the barrier of contamination from, bearing in the process of operation, regardless of debris or moisture can penetrate bearings, in case of causing damage to it. Have a bearing on the correct installation and maintenance is an important factor of the longest service life. At the same time, must pay attention to the correctness of the purity of the bearing, bearing selection and choose the proper installation and maintenance tools. In addition, the bearing must prevent polluted by contaminants and moisture, and ensure that the right be installed and lubrication. According to the classification of 5, grease main distinguish between temperature and working conditions: grease can be classified according to their allowable working temperature, lubrication grease consistency and ability is affected by temperature, operating under a certain temperature bearing must choose under the same temperature has the correct consistency and good lubrication effect of oils and fats. Oil is made of different working temperature range, can be roughly divided into low, medium temperature and high temperature with grease. At the same time, there is a certain type of oils and fats known as resistance to squeeze or extrusion and add molybdenum disulfide, at the same time, among them with additives to enhance the strength of the lubricating oil film. 6, rust resistance used in grease in the bearing must have antirust effect, rust inhibitor is best can not dissolve in water. Grease should have good adhesion, and can form a layer of oil film on the surface of steel. INA bearing lubrication for the stability of the role is also have certain effect, but also the meaning of the expression in this respect can correctly reflects the aspects of the effect, and sense also has changed a lot, which can better understand the meaning of this aspect.