Stainless steel bearings, stainless steel bearings of the common problems and treatment methods

Jiaxing bearing group sales co. , LTD. , is the spot sales center of jiaxing bearing factory, specializing in HRB bearings, application in production design and related machinery has a wealth of technical experience, today we are together and our experts to study the common problems and solutions of stainless steel bearing. 1. Bearing heating. If the bearing lubricating oil is insufficient, should go, and check whether the oil flow; If lubricating oil have impurities, should clean bearing, replace the new oil, cleaning filter; If bad assembly, journal and stainless steel bearing skew, biased, can be in the bottom of the bearing seat cushion; If the bearing gap is too small, should be to adjust the clearance. 2. Axis fever. If the oil baffle or rubber seal on the shaft is too tight, should adjust the packing back cover location; If the shaft friction with the stainless steel radial bearing cover, should check and adjust the shaft and bearing radial clearance, general is 0. 25 ~ 0. 3mm。 3. The main friction surface oil quantity is little. If the tubing plugging and oil groove shallow, should be cleaning tube, deepen oil groove; If the oil temperature is low, the liquidity is poor, should be replaced according to the environmental temperature lubricating oil; If the oil ring rotation is slow, poor oil splashing, should check whether the oil ring is off, grazing, the oil level is too high can drain to the standard height; If the adjusting shim block of lubricating oil, check the adjusting shim position. 4. The spill. If the oil amount is much, the oil should be adjusted, maintaining the oil level of standard height; If the seal failure, should be compression gland, thickening felt ring or replace the sealing material; If the bearing hole, oil leakage, should replace the bearing or with lead to blocked pores. 5. The axial beating. If the bearing gap is too big, should be removed from gasket, adjustment; If a body of revolution, Gear, belt wheel, etc. ) Dynamic balance is not good, should check and adjust active balance; If the bearing is not stable, should tighten bolts bearing; If coupling installed offset is big, should be in the bearing ground and gaskets, adjust the coupling installation accuracy. 6. Stainless steel bearing failure. Stainless steel bearing failure of the main reason is that defects and overload two factors. When the loads more than material strength limit fracture caused by parts called overload fracture. Overload reason mainly is the main engine failure or improper installation. Bearing parts of micro crack, shrinkage cavity, bubbles and large foreign impurities, overheating organizations and local burns and other defects during the impact overload or violent vibration will cause fracture in defect, known as defect fracture. It should be pointed out that the bearing in the process of manufacturing, for raw materials into the factory reinspection, forging and heat treatment quality control, process control through instrument analysis of the existence of the above defects and correct still must strengthen control in the future. But in general, usually most of the stainless steel bearing fracture failure for overload failure. If you are looking for the above jiaxing bearing factory introduction of stainless steel deep groove ball bearings are interested or have any questions, please click on contact us page on the right side of the online customer service, or call: 4006578186, jiaxing bearing retail center you full thoughtful procurement consultant. - - - - - - - - - - - Editor: stainless steel bearing sourcing consultant LTD. All rights reserved, Jiaxing bearing factory) Reprint please indicate the source