Intermediate frequency and high frequency induction how to distinguish?

Medium frequency induction, high frequency induction are two different products, the applicable artifacts and there is a difference between the basic configuration. So what circumstances respectively how to choose? The authors review with everybody together! The frequency of the medium frequency induction is 1 KHZ 20 KHZ, typical value is 8 KHZ, heating depth and thickness of about 3 - 10mm。 For larger workpiece more, large diameter shaft, large diameter thick wall pipe, big modulus gear artifacts such as heating, annealing, tempering, conditioning and surface hardening and the smaller the diameter of the bar is red, forging, etc. High frequency induction frequency is much higher, the frequency of 40 KHZ - Between 200 KHZ, commonly used 40 KHZ to 80 KHZ, heating depth and thickness of about 1 - More than 2 mm, deep heat for small parts, brazing, red punching, forging, annealing, tempering, tempering, surface quenching, medium the diameter of the heating pipe and welding, hot assembly, small gear quenching, etc. The heating of the workpiece material is also differentiated. Usually low carbon steel and low alloy steel with medium frequency, austenitic stainless steel, copper alloy, aluminum alloy and titanium alloy with high frequency. Based on these information, basic can distinguish between what is the use of any equipment. More specific, then can according to particular case is particular analysis, workpiece induction manufacturer service hotline:! 【 See who else in WTR bearing 】 : zhejiang hailiang CheJiaXing cement China wind power in China's hubei province is fitting click to see more customer case! The above articles from jiaxing Kurt automation equipment co. , LTD ( ） Reprint please indicate the source